The best places of choice for mildew to grow are the bathtub and the shower. Yet, you can adopt measure to keep these areas clean.
1. Clean your bathtub and shower at regular intervals.
2. Make the area as inhospitable for mildew as you can.
An easy way of keeping the bathtub and shower clean is to spray the tiled walls of the bathroom with mildew remove and leave it there for nearly fifteen minutes. In the meanwhile you may go ahead with the cleaning of the toilet.
By the time you come back to the bathtub and shower, the mildew remover has already done its job. Yet, there could be some soap scum, dirt and residual mildew that needs to be wiped or scrubbed off.
It will be helpful to have these tools and material at hand before starting the process of scrubbing.
- A Rinse Ace Sprayer With Valve
- Tub and Tile Cleaner
- Decalcifying Gel – for removing deposits of lime and calcium that get built up inside the showerhead and reduce the flow of water.
* In a bucket make a solution of water by adding tub and tile cleaner to it.
* Use a bathtub stopper. It prevents a build up in the drain causing it to clog up.
* Make use of rubber gloves to safeguard your hands.
Now, we are ready to get started.
You start by spraying water on the tiled shower walls and the bathtub by using a rinse ace sprayer. You start scrubbing only after water has been sprayed well all over the area. With the help of the tile and tub scrubber softly scrub away the dirt and scum that might have remained unaffected by the mildew remover.
Once you are satisfied that the shower walls and the bathtub have been scrubbed, take a rag, dip the same in the bucket and wipe the exterior of the bathtub. Now, rinse with a clean rag soaked in clean water and wipe the exterior of the bathtub once again. You are almost there, just spray down the shower walls and the tub to ensure that the residue caused by cleaning and scrubbing is removed.
Once you are finished with that, remove the bathtub stopper for cleaning it in the sink. Using a dry rag, wipe off the remaining moisture from the shower and bathtub to let it dry completely.
Finally, put a Sani-Clean Stick into the tub drain to keep it clear.